AXIAL SCX6 Replacement Motor Pinion 15T 1mm Pitch - SCX6015TS by GPM  [SCX6015TS]

AXIAL SCX6 JEEP JLU WRANGLER 4WD High Carbon Steel Motor Gear 15T - 2pc set - GPM SCX6015TS
Price:
£5.13
Brand:
GPM
Model:
SCX6015TS
GTIN:
4894538357653
Condition:
Brand New
Write a review
alt="AXIAL SCX6 JEEP JLU WRANGLER 4WD High Carbon Steel Motor Gear 15T - 2pc set - GPM SCX6015TS" title="AXIAL SCX6 JEEP JLU WRANGLER 4WD High Carbon Steel Motor Gear 15T - 2pc set - GPM SCX6015TS"
alt="AXIAL SCX6 JEEP JLU WRANGLER 4WD High Carbon Steel Motor Gear 15T - 2pc set - GPM SCX6015TS" title="AXIAL SCX6 JEEP JLU WRANGLER 4WD High Carbon Steel Motor Gear 15T - 2pc set - GPM SCX6015TS"
alt="AXIAL SCX6 JEEP JLU WRANGLER 4WD High Carbon Steel Motor Gear 15T - 2pc set - GPM SCX6015TS" title="AXIAL SCX6 JEEP JLU WRANGLER 4WD High Carbon Steel Motor Gear 15T - 2pc set - GPM SCX6015TS"
alt="AXIAL SCX6 JEEP JLU WRANGLER 4WD High Carbon Steel Motor Gear 15T - 2pc set - GPM SCX6015TS" title="AXIAL SCX6 JEEP JLU WRANGLER 4WD High Carbon Steel Motor Gear 15T - 2pc set - GPM SCX6015TS"

15T pinion gear in high carbon steel

This 15-tooth motor pinion is supplied as an aftermarket replacement for AXIAL SCX6 models, sized for small RC motors that match the specified shaft and pitch. The high carbon steel material provides increased wear resistance in drivetrain service compared with many stock pinions, transmitting motor torque into the gearbox assembly.

The part lists a 5mm centre hole and a 1mm tooth pitch; verify these against your motor shaft and existing pinion before fitting. Follow standard installation steps: verify gear mesh with the spur, secure the pinion using the supplied screw, and manually rotate the drivetrain to confirm smooth operation before powering up.

Packing includes

  • Pinion Gear - 1pcs
  • 4*4 Screw Shaft - 1pcs

Original Name / Part No:

ARA310961

Compatible Models

  • 1/6 4WD SCX6 JEEP JLU WRANGLER-AXI05000

Will this pinion fit a 540-size motor?

Fit depends on the shaft diameter and mounting method; if your 540 motor has a 5mm shaft and compatible securing screw, the pinion will fit physically.

How do I protect the spur gear when using this pinion?

Ensure correct mesh to avoid concentrated wear, keep gears clean of grit, and replace the pinion at signs of severe tooth wear to protect the spur.

Any advice for high torque setups?

For high torque motors, check that pinion pitch and bore match precisely, and consider routine inspections to detect early wear on both pinion and spur.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved