Axial Wraith Hardened 14T Steel Motor Pinion WR9014TS by GPM  [WR9014TS]

Axial Racing Wraith Steel Motor Pinion (14T) - 1pc - GPM WR9014TS
Price:
£2.88
Brand:
GPM
Model:
WR9014TS
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Wraith 14T Hardened Steel Motor Pinion

Hardened steel 14-tooth motor pinion suitable for Axial Wraith drivetrains, sold as an aftermarket replacement under model WR9014TS. It is intended to provide direct tooth-to-tooth engagement with the spur gear where a 14T pinion is required for the target final ratio.

Recommended for replacing worn pinions or for making gearing changes to suit different driving conditions. Steel construction gives consistent wear performance and stands up to repetitive removals and refits better than softer materials.

Installation advice: set the correct mesh between pinion and spur, verify axial placement on the motor shaft, and secure using the motor's existing retention method. Run a short check to ensure smooth rotation and acceptable backlash before full operation.

Which Wraith variants will accept this pinion?

Any Axial Wraith variant that requires a 14T motor pinion and uses a compatible shaft diameter and retention system should accept this part. Verify fitment before installation.

How does changing to a 14T pinion affect handling?

A 14T pinion alters the final drive ratio so the vehicle will typically gain acceleration and torque at lower speeds while reducing theoretical top speed compared with larger pinions.

How should I maintain the pinion?

Regularly inspect tooth faces for wear, confirm mesh remains correct after runs, and ensure retention hardware is secure to avoid slippage or damage.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved