Axial Wraith Steel 12T Pinion Gear WR9012TS by GPM  [WR9012TS]

Axial Racing Wraith Steel Motor Pinion (12T) - 1pc - GPM WR9012TS
Price:
£2.88
Brand:
GPM
Model:
WR9012TS
GTIN:
4894538196061
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
1 Reviews
Write a review

Steel 12T Pinion Optimised for Wraith

This steel 12-tooth motor pinion is an RC-scale replacement intended for Axial Wraith vehicles, supplied as 1 pcs. It is designed for changing final drive ratios where adjusting tooth count affects pull and low-speed control.

The durable steel construction and tooth geometry are aimed at longer service life under mesh load. Choosing the 12T option typically trades peak speed for improved low-speed tractability on technical terrain.

Installation pointers: fit the pinion so the set screw sits square on the shaft, check lateral alignment with the spur gear, and confirm correct clearance under working load. Run a gentle test after fitting to spot any mesh issues or abnormal noise before heavy use.

Supplied: 1 pcs, steel 12T motor pinion, single-piece pack.

 

Product Reviews
1 Reviews
rating
ordered some transmission gears for my yeti XL got here faster then the transmission case i ordered from ebay was a pleasurable experience will order from GPM again

Can I use this on any Wraith variant?

It is intended for Axial Wraith platforms, but you should confirm shaft dimensions and coupling type to ensure compatibility with your specific variant.

How often should I inspect the pinion?

Inspect teeth and set screw tightness periodically, especially after heavy runs, and replace if you notice tooth wear or deformation.

Any tip for quieter operation?

Set a correct slight backlash, ensure the pinion is fully seated and set screw is secure, then lubricate bearings and check spur gear condition to reduce noise.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved