Axial Wraith Transmission Main Shaft Pair SWR037 by GPM  [SWR037]

Direct-fit main shafts for the Wraith transmission

This hardened steel main shaft set is supplied as a pair and serves as a direct-fit replacement for the Axial Racing Wraith drivetrain. It is used to renew drivetrain straightness and to replace shafts that have become worn or distorted.

The shafts are produced from hardened steel to resist deformation under the typical demands of trail and rock-crawling driving. When installing, ensure correct seating in the gearbox and hub bores and check clearances to the spur gear and bearings to avoid binding.

Installation advice: remove the drivetrain so you can inspect bearings and retaining hardware, install the replacement shafts in the original orientation, and confirm free rotation by hand prior to completing reassembly. Consider these components as routine wear parts during transmission servicing.

Use this shaft pair when correcting drivetrain geometry or replacing worn transmission parts on Axial Wraith models, and inspect mating components for condition and fit.