Axial Yeti 2.2 Wheel Offset Adapters 22mm Thickness YT022C by GPM  [YT022C]

2.2 inch wheel hub adapters compatible with Axial Yeti

This aluminium hub adapter set is intended to alter wheel offset on 2.2" wheel and tyre combinations. Supplied as a pair, the adapters increase the lateral gap between wheel and hub, allowing you to change track width and stance without altering hubs or axle components.

The adapters are presented as 22mm thick aluminium for platform use and act as a simple upgrade for clearance and handling adjustments on rock racers and crawlers. Fitment and handling outcomes will vary by tyre profile, wheel backspacing and suspension tune, so inspect wheel-to-shock and wheel-to-link clearances prior to running.

Installation is a straightforward hub swap: remove the wheel, unbolt the stock hub or wheel hex as appropriate, fit the adapter to the hub or axle according to your chassis layout, then refit wheel hardware and confirm rotational clearance and hex engagement. Use correct hex screws and recheck bearing alignment after fitting to avoid binding.