Axial Yeti XL Steering Link Upgrade Aluminium Centre Rod with Plastic Ends YTL047P by GPM  [YTL047P]

Axial Racing Yeti XL Aluminium Steering Rod With Plastic Ends - 1pr set - GPM YTL047P
Price:
£8.10
Brand:
GPM
Model:
YTL047P
GTIN:
4894538245059
Condition:
Brand New
Write a review

Aluminium centre steering rod for Yeti XL rigs

This steering rod is supplied as an aftermarket 1pr set for the Axial Racing Yeti XL platform. It uses an aluminium inner rod combined with plastic end fittings to preserve the stock ball interface while offering a firmer metal shaft that reduces flex compared with fully plastic links.

Suitable for trail and rock crawling applications where consistent steering feedback matters, the part fits the existing ball studs and linkage points. After installation, check and adjust steering trim and toe to maintain proper geometry and handling balance.

Keep to hobby use, check all fasteners and ball joints routinely, and replace the rod if the plastic ends show degradation to avoid unexpected steering play.

Is this a direct swap for stock rods?

Yes, the rod is made to fit the Yeti XL linkage points and uses the same ball end interfaces as the factory parts.

Will the aluminium shaft rust?

The aluminium inner shaft resists corrosion better than steel; however rinse and dry after wet runs and check for grit that can accelerate wear on joints.

Recommended setup checks after fitting?

Confirm there is no binding across full steering travel, set neutral trim, and periodically inspect the plastic ends for wear to keep steering predictable.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved