RTC Graphite Rear Suspension Arm for BD9 Series 53mm x 40mm - Yokomo B9-RTC-01A  [B9-RTC-01A]

Yokomo B9-RTC-01A RTC Graphite Rear Suspension Arm (53mm-40mm)
Price:
£8.68
Brand:
Yokomo
Model:
B9-RTC-01A
GTIN:
0639342182725
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - MRTC-BD10FF category
Write a review

Graphite RTC Rear Suspension Arm Details

This graphite rear suspension arm is specified for the BD9 RTC arrangement and is intended as a replacement for 1/10 electric touring RC chassis. It preserves RTC geometry with a 53mm separation between inner and outer suspension pins and a 40mm shock pivot spacing to match original RTC locations.

Only the chassis codes listed below are compatible, so verify your chassis before purchase. Installation follows the same mounting points as the stock RTC arm; remove the old arm and move any necessary pins or hardware to the new arm. Check pin seating and retaining clips when assembling to make sure everything is secure.

The graphite arm is intended to preserve or restore RTC suspension geometry for maintenance or straightforward tuning swaps. It works with standard RC suspension pins and shock setups for the supported models listed below.

Chassis compatibility

  • MRTC-BD919
  • MRTC-BD919S
  • MRTC-BD10FF
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Which BD9 variants will accept this RTC arm?

The arm is compatible with the chassis codes listed above. Confirm your chassis code matches one of those entries before ordering to ensure correct fitment.

How should I check fit after installation?

After fitting, inspect pin alignment, clip retention and shock mounting clearance. Run a short on-track check and re-tighten any fasteners that settle during the initial run.

Does the arm require any trimming or alteration?

No trimming is expected for compatible chassis. Use the stock mounting hardware and verify clearances; only replace the arm if damage or interference is detected.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved