Baja BJ186f Steel Shock Shaft BJ186F/SH Replacement for HPI Baja by GPM  [BJ186F/SH]

HPI Baja Steel Shock Shaft For Bj186f - 1pr - GPM BJ186F/SH
Price:
£2.38
Brand:
GPM
Model:
BJ186F/SH
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Replacement rod for Baja BJ186f

This steel shock shaft is produced for the HPI Baja BJ186f platform and delivered as model BJ186F/SH to serve as a direct replacement rod for scale Baja shock assemblies.

Fitting advice: dismantle the shock, remove the old rod and internals, inspect seals and washers for damage, then install the new steel rod and reassemble using the correct shock oil and spacer stack for your setup.

The shaft helps maintain piston alignment and resist bending under heavy off-road use, offering a reliable sliding surface that minimises binding when altering valve shims or spacer stacks; it should be used as an aftermarket suspension component only.

Does this replace the stock shock shaft?

Yes, it is intended as a direct replacement for the stock shock rod on the HPI Baja BJ186f shock assemblies.

What maintenance should I perform after fitting?

Check seals and O-rings for correct seating, verify spacer stack height, and ensure oil level is correct to avoid air pockets that affect damping.

Is this suited to heavy off-road use?

The steel construction is intended to reduce flex and wear, making it suitable as an upgrade where heavier off-road loads can cause stock shafts to bend.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved