BAJA Front Suspension Nylon Ball Ends BJ186F/BE by GPM  [BJ186F/BE]

Replacement ball ends for BAJA front dampers

This 2-piece set supplies nylon ball ends with captive balls for front damper linkages on BAJA-scale RC cars, referenced as BJ186F/BE. The components are moulded nylon designed to seat on typical BAJA ball studs and restore correct linkage geometry.

Use case: intended as direct replacements where wear or damaged fittings cause play at the damper-to-link joint, bringing back confident steering response and predictable suspension travel.

Installation notes: remove the worn end from the stud, place the captive ball into the cup, then press the replacement onto the stud until secure. Cycle the suspension to confirm full, free articulation and fit the opposite side if wear is visible to keep handling consistent.

Tuning role: nylon ball ends provide a low-mass pivot point for front dampers, useful for maintenance swaps and minor setup adjustments without adding extra weight to the suspension.