BD10 Front-Side NA Rear Suspension Mount B10-301SA Yokomo  [B10-301SA]

Yokomo B10-301SA Aluminum separate NA rear suspension mount (Front) for BD10
Price:
£16.39
Brand:
Yokomo
Model:
B10-301SA
GTIN:
0639342202508
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - MRTC-BD10FF category
Write a review

Front mounting point for BD10 rear suspension

This aluminium NA rear suspension mount is intended for the front side of the rear suspension on BD10 touring car chassis. It is a machined upgrade to replace the original plastic mount and to provide a firmer mounting point for consistent setup references.

The item fits the BD10 family listed below and serves to stabilise the rear upper and lower mounting geometry, supporting small adjustments to roll centre and arm positions when paired with standard BD10 suspension components. Installation normally involves removing the stock mount and refitting with suitable hardware.

Emphasis is placed on compatibility and setup function rather than appearance. Confirm your BD10 rear bulkhead and hardware will accept the aluminium part and use hand tools to protect threads during installation.

Product specifications

  • Item: Aluminum separate NA rear suspension mount (Front)
  • Material: Aluminum
  • Model Number: B10-301SA
  • Compatibility: MRTC-BD10, MRTC-BD10A, MRTC-BD10FF, MRTC-BD10LC, MRTC-BD10LCA, MRTC-BD10LCR, MRTC-BD10LCRA

Compatible Models

  • MRTC-BD10
  • MRTC-BD10A
  • MRTC-BD10FF
  • MRTC-BD10LC
  • MRTC-BD10LCA
  • MRTC-BD10LCR
  • MRTC-BD10LCRA

Use this aluminium front-side rear suspension mount to achieve a stable, repeatable pivot on BD10 platforms; always verify fit and recheck suspension geometry after installation.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can this mount be used on all BD10 variants listed?

The mount is designed for the BD10 variants named in the compatibility list. Double-check the bulkhead layout on your specific variant to confirm there are no local differences before fitting.

Will aluminium threads require different care?

Treat aluminium threads with care: tighten progressively by hand and avoid excessive torque. Consider thread locker where appropriate and ensure screws are the correct length.

Does this improve tuning repeatability?

Yes. The aluminium mount reduces flex at the mounting point, which stabilises pivot geometry and makes setup changes more consistent from run to run.

Any recommended installation checks?

After fitting, cycle the suspension through full travel to check for binding, then re-torque fasteners and confirm alignment before track use.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved