Compact Mini 4WD Mass Damper Cuboid 9g M4WD-39/PK Pink by 3Racing  [M4WD-39/PK]

Tamiya Mini 4WD cuboid Weight 9g -Pink - 3RACING M4WD-39/PK
Price:
£2.84
Brand:
3Racing
Model:
M4WD-39/PK
Condition:
Brand New
Write a review

M4WD-39/PK pink cuboid mass damper 9g

This compact 9 gram cuboid is supplied as a replacement mass damper for Mini 4WD hobbyists tuning balance and rebound on 4WD-compatible chassis. The slim, solid block is designed to sit in tight locations and short damper stays where larger dampers will not fit.

Installation note: the component is an accessory weight rather than a kit part. Because mounting geometry and finishes vary, check the stay profile and any screw hole alignment prior to final fitment. Avoid altering chassis mounting points in ways that could impact flex or handling characteristics.

Scope: the cuboid is intended for chassis that accept added mass dampers to refine handling. It is not a drivetrain upgrade and should not replace parts created specifically for Wild Mini 4WD or Scale Mini 4WD variants.

How to confirm the M4WD-39/PK will mount correctly?

Measure the internal width of the damper stay and verify hole positions. A temporary clamp fit will show if gaps or interference exist before you commit to permanent fixing.

Does adding this weight change jump behaviour?

Additional mass can alter trajectory and landing response. Small changes are typically subtle, so test on a familiar track and tune placement accordingly.

Any finishing advice before fitting?

Lightly remove flash or burrs if present, but do not remove significant material that would drop the mass below 9g if consistent weight is important for testing.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved