Compatible DRB/DIB Aluminium Front Suspension Arm - YOKTS2142 by Yokomo  [YOKTS2142]

Yokomo TS-2142 - Team Suzuki HG Aluminium Front Suspension Arm 1mm wide/Black for DRB/DIB
Price:
£39.69
Brand:
Yokomo
Model:
YOKTS2142
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - DRB category
Write a review

Front arm designed for DRB and DIB fitment

The Yokomo YOKTS2142 is an aluminium front suspension arm produced for RC touring cars that employ the DRB or DIB chassis platforms. As a replacement component it provides a firmer mounting location for the front suspension and is intended for hobby use only.

This arm is supplied as a single machined aluminium part with a 1mm width and a black anodized finish. It fits into the front suspension assembly to adjust steering characteristics and roll behaviour; installers should verify fit with their DRB or DIB hubs and mounting hardware prior to fitting. Use with standard suspension linkages to tune toe and stiffness.

Fitment guidance: inspect ball studs and mounting pins for wear, orient the arm to match the hub carrier geometry, and torque fasteners to the chassis manufacturer's recommended values. Use threadlocker on metal-on-metal fasteners only when required by your setup. This component is for 1/10 scale RC touring cars and is not intended for full-size vehicle use.

Specifications

  • Item: Front suspension arm (RC scale)
  • Material: Aluminium
  • Model Number: YOKTS2142
  • Compatibility: DRB, DIB
  • Color: Black
  • Width: 1mm

Compatible Models

  • DRB
  • DIB

Opt for this aluminium arm when you want a direct front suspension replacement to influence handling on DRB or DIB touring car chassis; fit with compatible hardware and adjust setup as required.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Does this arm fit both DRB and DIB without modification?

It is designed to work with DRB and DIB front assemblies, but small differences in aftermarket hubs or worn components can affect fit. Always trial-fit and check clearances before final assembly.

Are any extra spacers or shims required?

Most standard DRB/DIB setups will accept the arm without additional shims, though some custom or modified hubs may need shims to correct alignment. Verify alignment during test fitting.

Will existing ball studs and pins fit the aluminium arm?

In general, standard ball studs and mounting pins used on DRB/DIB front ends will fit, but inspect for wear and replace hardware if tolerances are out of spec to ensure proper function.

What should I check after first installation?

After fitting, confirm steering range, check for binding, recheck fastener torque, and perform a short test run to verify handling changes before full use.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved