Destiny D10246 Long 4.3x17mm Steel Ballstud for RX-10SR 2.0  [DES-D10246]

Destiny DES-D10246 Steel 4.3x17mm Ballstud (Long)
Price:
£4.48
Brand:
Destiny
Model:
DES-D10246
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

High strength steel ballstuds suited to RX-10SR 2.0

The Destiny D10246 Steel 4.3x17mm Ballstud (Long) is intended for the RX-10SR 2.0 chassis and provides a tougher contact point for suspension linkages. Made from hardened steel, these studs improve resistance to wear and help preserve accurate suspension geometry during repeated track use. They are a solid choice for tuners aiming for consistent handling and reduced hardware replacement intervals.

How do I check thread compatibility before fitting?

Measure the thread diameter and pitch on the original stud or consult the chassis manual to confirm the new stud matches before attempting to fit it.

Is there any break-in required for steel ballstuds?

No special break-in is needed, but inspect mating parts after a few runs to ensure there is no unusual wear where steel meets plastic or composite components.

Can I use threadlock when installing these studs?

Light threadlock can be used if you experience studs loosening, but choose a removable-strength product so parts can be serviced without damage.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved