DP-DPR Left Steering Bell Crank D-127L (Aluminum) for DP-DPR by Yokomo  [D-127L]

Yokomo D-127L Aluminum Steering Bell Crank (L) for DP-DPR
Price:
£5.29
Brand:
Yokomo
Model:
D-127L
GTIN:
3888
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - DP-DPRA category
Write a review

Aluminum left bell crank for DPR family

The D-127L is the left-side aluminum steering bell crank supplied for the Drift Package DPR family of chassis. It replaces the left steering bell crank in the steering linkage between the servo and tie rods on DPR-series vehicles.

Fitment is limited to the DP-DPR platform and the supported variants DP-DPMS and DP-DPRA. Confirm measurements against the original component to ensure correct installation on your model before proceeding.

Installers familiar with DPR steering assemblies will remove the original left bell crank, verify alignment of the servo output arm and steering linkage, and fit the D-127L in the same orientation as the factory item. Check ball bearings and mounting hardware for wear and use appropriate hex drivers to torque fasteners to the recommended settings.

Intended as a replacement/service component, the D-127L helps maintain steering geometry during repairs and setup work rather than offering an aftermarket performance enhancement.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is the D-127L a direct swap for the original DPR bell crank?

Yes. When dimensions match the factory part, the D-127L is intended as a direct left-side replacement for DP-DPR and the listed DP-DPMS and DP-DPRA variants.

Should I replace bearings when fitting the new bell crank?

Inspect and, if necessary, replace worn ball bearings and any degraded fasteners before installing the D-127L to ensure reliable steering action.

Does this part change steering balance or handling?

The part is neutral in design and intended to preserve the existing steering geometry; it should not alter handling when used as a like-for-like replacement in DPR-series setups.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved