This red anodized aluminum slide rack set is an RC-scale front slide rack and front bulkhead assembly made to replace the stock front rail on compatible drift and touring chassis. Milled rails and a machined bulkhead aim to cut mass at the front while retaining stiff contact points.
Fitting the unit to a resin chassis increases front-section stiffness, which can reduce front-tyre hook on corner entry and offer a more consistent steering feel. The forward-angled rack geometry is designed to create an Ackermann setup that favors drifting, allowing finer adjustments to inside and outside wheel angles during controlled slides.
Installation is carried out in the standard manner: remove the OEM front rail, line up the new bulkhead with the chassis mounting holes and fasten with the original hardware. No additional components are normally necessary beyond those referenced in the compatibility listing. After installation, adjust toe, steering throw and suspension to rebalance handling to your driving preference.
Intended for drivers wanting a stiffer front area and a drift-biased Ackermann profile on supported DP and RDR platforms; plan to fine-tune toe and steering throw after fitting to align handling with your driving approach.
Copyright © 2008-2026 rcjaz.co.uk All rights reserved