DT-03 Aluminium Front Lower Arm Replacement JR-DT300-OR for TAMIYA by Jazrider  [JR-DT300-OR]

Tamiya DT-03 Aluminum Front Lower Suspension Arm (Orange)
Price:
£11.22
Brand:
JAZRIDER
Model:
JR-DT300-OR
Condition:
Brand New
Available in shop
Write a review

DT-03 front lower suspension arm - aluminium upgrade

This front lower suspension arm is intended for use on the TAMIYA DT-03 chassis and is supplied as model JR-DT300-OR. It is CNC machined from anodised orange aluminium to substitute the factory plastic lower arm while matching the DT-03 mounting interfaces.

As an upgrade the aluminium arm stabilises the suspension mounting points, which improves the consistency of alignment and setup changes under running conditions. It is compatible with standard DT-03 suspension assemblies and ball cups; confirm your existing fasteners and ball stud positions before proceeding.

Fitting guidance: move the original mounting hardware to the new arm where suitable, align with the hub carrier and steering linkage, tighten fasteners to a controlled torque to prevent thread damage, and check suspension travel and steering clearance after installation.

Will this arm work across different DT-03 kit versions?

The arm follows the DT-03 lower arm mounting layout, but some kit variants may use altered components. Verify your chassis uses the standard DT-03 lower arm points before purchasing.

Are there any compatibility notes with hub carriers or steering blocks?

Ensure your hub carrier and steering linkage accept the same ball cup spacing and stud heights as the original arm; slight differences in hardware can require replacement or adjustment.

Can I expect improved lap times after fitting?

While the arm improves setup repeatability and durability, lap time gains depend on overall setup and driver input; use the arm to facilitate more consistent fine-tuning rather than as a standalone performance fix.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved