Eagle Freya Compatible 20T Bevel Gear with Shaft HI0414177 by Hirobo  [HI0414177]

HIROBO 0414-177 BEVER GEAR 20T WITH SHAFT #0414177
Price:
£10.91
Brand:
Hirobo
Model:
HI0414177
GTIN:
4572295126209
Condition:
Brand New
Write a review

HI0414177 Bevel Gear and Shaft — Compatibility Notes for Eagle Freya

The Hirobo HI0414177 is an RC spare bevel gear supplied with its shaft and intended for use in Eagle Freya helicopter assemblies. It is designed to replace a damaged or worn 20T bevel gear and restore the intended meshing between the gearbox and the bevel gear.

Fitment advice: confirm correct seating of the shaft and set axial clearance before completing assembly. Check engagement at low throttle and ensure surrounding bearings spin freely. Apply thread locker only where the kit documentation requires, and avoid excessive torque that can preload bearings or distort alignment.

Inspection checklist: when fitting the replacement, review adjacent components including bearings and the mating pinion for wear that could have caused the original failure, so the new gear is not compromised shortly after installation.

Is this an OEM part or an aftermarket replacement?

This is supplied as a compatible replacement for Eagle Freya models; confirm fit and specs against your kit before installation to ensure correct application.

Can I expect direct bolt-on fitment?

Often it will fit without modification, but always check shaft seating and gear mesh; small adjustments to shims or bearing positions may be necessary to achieve ideal alignment.

Where should I check for related wear that affects compatibility?

Inspect the mating pinion teeth, gearbox bearings, and shaft journals for scoring or play, as these can prevent correct mesh even when the replacement gear itself is sound.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved