EDS 150247 3/16 Inch Nut Driver 100mm Shaft Precision Tool  [EDS-150247]

EDS 150247 - NUT DRIVER 3/16inch (4.763MM) X 100MM
Price:
£9.27
Brand:
EDS
Model:
EDS-150247
Condition:
Brand New
Write a review

Precision Nut Driver for RC Servicing

The EDS 150247 Nut Driver, sized at 3/16 inch (4.763mm) with a 100mm shaft, is aimed at modelers needing controlled torque and reach. It forms part of EDS's SAE series and is specified for routine service tasks.

Engineered Spring Steel Tip

Produced from specially treated EDS spring steel, the driver resists deformation and maintains tip integrity under repeated cycles. The material choice helps ensure consistent engagement with fasteners.

Suitable for Common Maintenance Jobs

Appropriate for tightening nuts and carrying out fine adjustments, its length and tip size make it a useful addition to a modeler's tool collection.

Which parts of an RC model typically use 3/16 inch nuts?

3/16 inch nuts are commonly found on older or SAE-specified RC hardware, wheel hubs and accessory mounts; always match the tool to the fastener for best results.

Should I use this driver for final torqueing?

It is suitable for accurate tightening, but for critical torque settings use a torque-limited tool or refer to manufacturer specs to avoid overtightening.

Any tips for preventing rounded nuts?

Ensure the driver tip fully seats on the nut before applying force, use correct alignment, and replace the driver if the tip shows wear.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved