EDS 160135 Arm Reamer 3.5 x 120mm Tuning Tool  [EDS-160135]

EDS 160135 - Arm Reamer 3.5 X 120mm
Price:
£8.39
Brand:
EDS
Model:
EDS-160135
Condition:
Brand New
Write a review

Accurate setup with EDS 160135 Arm Reamer

The EDS 160135 Arm Reamer is intended for model makers and racers who need to opent and true up suspension arm holes. With a 3.5mm diameter and 120mm length it helps achieve consistent pivot sizing for dependable assembly.

Get consistent pivot geometry

Opening pivot holes to the correct diameter reduces slop and helps keep suspension geometry consistent under load. A true hole improves part life and preserves predictable handling.

Comfortable use for routine tuning

The tool is shaped for steady manual operation and built to endure repeated use. It suits workshop tuning sessions where precision and control are priorities.

Will the EDS 160135 damage bearings if used carelessly?

If used without care the tool can oversize holes and affect bearing fit. Take measured passes and check fit often to avoid loosening bearing seating.

What is the best technique for neat holes?

Secure the arm, centre the pilot mark and rotate the reamer with steady pressure. Remove swarf frequently and test fit until the desired tolerance is reached.

Does the tool suit both front and rear arms?

Yes, the 120mm shaft gives good reach for most front and rear suspension arms, allowing neat work on both ends of the chassis.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved