EDS 160140 Precision Arm Reamer 4.0 X 120mm  [EDS-160140]

EDS 160140 - Arm Reamer 4.0 X 120mm
Price:
£8.39
Brand:
EDS
Model:
EDS-160140
Condition:
Brand New
Write a review

Precision Reamer for Suspension Holes

The EDS 160140 Arm Reamer is designed for RC model tuners who want predictable, straight holes in suspension arms. The tool's 4.0mm diameter and 120mm length make it suitable for refining or restoring mounting bores to reduce binding and slop.

Control and Consistency

Use the EDS 160140 to produce repeatable hole geometry that improves alignment of pins and bushings. The 4.0mm profile produces a true bore while the 120mm shaft helps reach deeper mounting positions on many chassis layouts.

Maintenance and Best Practice

Regular inspection and light reaming keeps pivot points free and responsive. The EDS 160140 Arm Reamer simplifies removing burrs and correcting ovalised holes so parts operate as intended.

Will the EDS 160140 work with aftermarket hinge pins and bushings?

The 4.0mm diameter is compatible with many common hinge pin sizes. Verify the pin diameter before reaming and adjust technique to achieve the required clearance.

How do I check for correct hole alignment after reaming?

Trial-fit the pin or bushing and cycle the suspension through its travel. Look for smooth movement and even contact without lateral play. Re-ream lightly if needed.

Any tips for using the 120mm length in tight chassis areas?

Support the workpiece firmly and work in short, steady strokes to maintain control. The longer shaft helps reach recessed holes but requires a steady hand to avoid wobble.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved