EDS-160125-L Arm Reamer 2.5 x 120mm Lightweight Setup Tool  [EDS-160125-L]

Price:
£9.05
Brand:
EDS
Model:
EDS-160125-L
Condition:
Brand New
Write a review

Precision Bore Tuning Using the EDS-160125-L

The EDS-160125-L Arm Reamer offers a simple way to true suspension arm holes with a 2.5 x 120mm cutting profile. Its low mass design removes unwanted material without compromising balance.

Advantages for Suspension Performance

True, deburred holes reduce stiction and uneven wear on pins and bushings. A clean bore promotes consistent steering and suspension reaction during demanding runs.

Who Will Appreciate This Reamer

Suitable for competitive tuners and hobbyists who regularly service or upgrade arms. The tool speeds up setup checks and helps maintain consistent geometry after part swaps.

What preparation should I do before reaming with the EDS-160125-L?

Clean the arm thoroughly and clamp it securely to prevent movement. Mark the bore centre and use light, steady strokes to avoid oversize cuts.

Will this tool affect hinge pin tolerance?

When used carefully, the reamer restores the intended tolerance by removing irregularities. Check clearances with the pin and ream in small passes for control.

Any tips for safe reaming practice?

Use a guide or jig where possible, keep speeds low, and inspect the tool edge before each use. After reaming, deburr and test-fit components to confirm correct operation.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved