This RC-scale caster block hub set is designed specifically for the Element Enduro Trail Truck chassis and carries the model number JR-EE02-BK. The kit replaces the factory caster block area with machined aluminium parts to adjust steering rigidity and chassis feedback without suggesting general vehicle changes.
Intended compatibility is limited to the Element Enduro Trail Truck; select this assembly when a firmer caster block mounting point is required to influence steering response and front-end behavior on trail runs. Do not presume compatibility with other models unless the retailer lists them.
Installation is straightforward as a direct replacement: remove the original caster block parts, transfer any reusable fasteners and steering components, install the aluminium hub set into the existing mounting points, and ensure adequate wheel and suspension clearance. After fitting, confirm steering travel and toe alignment prior to use.
In setup terms this component increases stiffness around the front knuckle and will change how steering inputs are transmitted through the suspension. Consider fitting the hub set with clean ball bearings and revisiting front preload to manage handling and wear patterns.
Copyright © 2008-2026 rcjaz.co.uk All rights reserved
