Factory Pro FP-M-AC3030OG Orange Gold 3mm x 3.0t Collar Pack 10pcs  [FP-M-AC3030OG]

Price:
£1.95
Brand:
Factory Pro
Model:
FP-M-AC3030OG
Condition:
Brand New
Write a review

Setup-Focused Collar Spacers for RC Enthusiasts

Factory Pro FP-M-AC3030OG 3mm x 3.0t collars are supplied in a 10-piece set with an orange gold finish to assist fast identification. These collars are precision sized to provide repeatable spacing and steady component location in model builds.

Typical Uses During Builds

Employ these 3mm collars when adjusting wheel hubs, stabilising linkages, or setting suspension clearances. The bright finish helps when working under varied lighting and makes routine checks quicker.

Model Range and Suitability

Designed to suit a wide selection of hobby cars, both tarmac and dirt rigs, these collars are a simple way to improve alignment consistency across assemblies requiring 3.0t collars.

What maintenance do these collars need?

Inspect the set screws and collar surfaces periodically for loosening or wear. Clean away grit that can affect seating and retighten to specification after a few runs.

Are these collars good for competitive use?

Yes, they are suitable for club and competition use as long as they are correctly installed and checked between heats. Their machined tolerances support consistent setup behaviour.

Do they come in other finishes or sizes?

This listing covers the 3mm x 3.0t orange gold variant. For other finishes or dimensions, check the wider Factory Pro range to match your project requirements.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved