Factory Pro FP-M-AC5010RD 5mm x 1.0t Red Collar Set 10 pcs  [FP-M-AC5010RD]

Price:
£3.75
Brand:
Factory Pro
Model:
FP-M-AC5010RD
Condition:
Brand New
Write a review

Factory Pro Red Collars for Consistent Spacing

The Factory Pro FP-M-AC5010RD 5mm x 1.0t red collar is a small but useful component for achieving repeatable spacing in RC models. Supplied as a ten piece set, these collars are practical for both routine tweaks and larger rebuilds.

Where to Use These Spacers

These collars are suited to applications that need stable gaps, such as axle spacing, link geometry adjustments, or setting end play. Their 5mm diameter and 1.0t thickness make them compatible with many common hobby parts.

Installation and Service Advice

The collars are straightforward to fit by sliding them onto the shaft and checking seating and alignment. For long runs, confirm they are secured by any existing retaining method on your model to prevent movement under load.

Are these suitable for touring cars and buggies?

They suit a wide range of models including touring cars and buggies where 5mm shaft spacing is used, though always check fit on your specific parts.

How do I check collar alignment after fitting?

After installing, rotate or cycle the affected assembly by hand to ensure there is no binding and that the collar remains in the intended position.

Can these collars be used as tuning shims?

Yes, they are commonly used as tuning shims to fine tune ride height, steering geometry or driveline alignment; change one increment at a time and test the result.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved