Factory Pro FP-O-BT0101RD Red Belt Tensioner Kit for RC Cars  [FP-O-BT0101RD]

Price:
£6.62
Brand:
Factory Pro
Model:
FP-O-BT0101RD
Condition:
Brand New
Write a review

Keep belts aligned using the Factory Pro FP-O-BT0101RD

Hobbyists aiming for dependable drivetrain behaviour can use the Factory Pro FP-O-BT0101RD Belt Tensioner Set to limit belt movement and cut down on uneven wear. It is a straightforward add-on for belt-driven RC layouts.

Construction and Bearing Details

The red anodised body gives a durable finish that stands up to handling, while the 3x6mm bearing ensures the tensioner spins freely and maintains steady pressure on the belt.

Practical Setup Steps

Install the tensioner with the belt centred on the pulleys, then tighten the mounting hardware gradually. Run a brief test and fine tune the alignment to avoid premature belt damage.

How do I check if the tensioner fits my car?

Measure your existing belt path and pulley clearances and compare them to the tensioner mounting points; this will confirm whether the FP-O-BT0101RD can be positioned correctly.

Will this reduce belt stretch?

While it will not stop material stretch entirely, keeping consistent tension limits excessive movement and helps belts last longer under normal use.

Is any extra hardware required?

Most installs use existing mount points, but small spacers or longer screws may be needed on some chassis. Verify hardware compatibility before fitting.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved