FAZER D2 Steel Steering Linkage FA630 Kyosho  [KY-FA630]

Kyosho FA630 - Steel Turnbuckle Rod set (FZD2)
Price:
£12.34
Brand:
Kyosho
Model:
KY-FA630
GTIN:
4548565522866
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 £9.91 each £4.87 or 20%
3+ £9.42 each £8.79 or 24%
Write a review

Steel Replacement Turnbuckles for FAZER D2

This FA630 steel turnbuckle rod set is supplied as an RC-scale replacement for the FAZER D2 chassis kit. It focuses on providing a more rigid, serviceable linkage option for steering and toe adjustment in on-road drift setups and is intended solely for model-scale use.

Compatibility is confined to the FAZER D2 chassis kit and its provided mounting points, so confirm fitment with your specific car before installing. Steel offers higher rigidity compared with typical plastic linkages and helps keep steering response and toe settings steadier while tuning.

Installation guidance: replace one end at a time to maintain suspension geometry, inspect thread engagement and ball studs for wear, and use a suitable hex driver to avoid over-torquing. Perform routine inspections after initial runs to ensure settings remain consistent and there is no binding.

Compatibility

  • FAZER D2 chassis kit
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What should I check before fitting the FA630 rods to my FAZER D2?

Verify the mounting points and ball stud types on your FAZER D2 variant to ensure the turnbuckle lengths and ends match the kit's layout.

Will these rods improve steering consistency on the track?

Yes, the increased rigidity of steel reduces unwanted flex and can make steering inputs and toe settings more predictable during runs.

Are any special tools required for installation?

No special tools are required beyond the correct hex driver for the turnbuckles; hand-run threads first and then tighten to a firm but not excessive torque.

How should I schedule inspections after installing these?

Check after the first few driving sessions and then periodically depending on use; inspect threads, ball studs and look for any loosening or wear.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved