O-AP0001 Compatible 40T 48pitch Spur Gear for Precision Setup - Awesomatix A800MMX by Factory Pro O-AP0009  [FP-O-AP0009]

Price:
£7.47
Brand:
Factory Pro
Model:
FP-O-AP0009
Condition:
Brand New
Write a review

Spur gear replacement for O-AP0001

This 48pitch 40-tooth spur is offered as an aftermarket replacement suitable for the O-AP0001 platform. It engages with the motor pinion to establish the drivetrain ratio and control mesh behaviour.

Use the 40T spur when performing a direct swap of the original large gear or while experimenting with alternative gearing during setup. Installation requires correct axial positioning and careful pinion mesh adjustment, ensuring the gear runs true on its bearings and clears the gearbox housing.

When setting up, verify pinion-to-spur engagement at low throttle, check bearings and any backlash, and confirm smooth rotation through the full range of steering and suspension travel. Altering spur tooth count changes final drive, so pair the 40T with the right pinion to achieve the balance you want between acceleration and top speed.

Does this fit the O-AP0001 without machining?

Yes, it is designed for the O-AP0001 spur location and should install without modification when the original mounting arrangement is used.

How do I check for correct backlash?

Set mesh with a small test under low throttle, rotate the drivetrain and feel for free movement; inspect for minimal but present backlash and no binding under steering or suspension movement.

Is changing spur size a common tuning step?

Yes. Altering the spur tooth count is a standard way to adjust final drive; couple the 40T with a suitable pinion to dial in either stronger acceleration or higher top speed depending on your needs.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved