XRAY X4'24 Graphite Rear Body Post Mount for Setup Consistency - Factory Pro O-XCP020  [FP-O-XCP020]

Price:
£10.07
Brand:
Factory Pro
Model:
FP-O-XCP020
Condition:
Brand New
Write a review

Rear body post mount compatible with XRAY X4'24

The Factory Pro O-XCP020 rear body post mount is an RC replacement component specified for the XRAY X4'24 chassis. Fabricated from graphite 4.0, it secures the rear body posts and recreates repeatable mounting points so setup adjustments remain consistent across sessions.

To install: remove the body, undo the existing mount fasteners, position the Factory Pro mount so its locating features match the chassis, then tighten using the original screws. No alterations to a standard X4'24 chassis are necessary.

As part of tuning, this mount manages rear body height and lateral rigidity, impacting aerodynamic balance and weight transfer during cornering. Using a graphite 4.0 mount delivers a stable reference for incremental body shifts and helps preserve consistent results from run to run.

Will this work with modified X4'24 setups?

This item targets the standard XRAY X4'24 layout. If your car has aftermarket modifications double check the mount locating points before fitting to ensure correct alignment.

Does the graphite affect durability?

Graphite 4.0 offers a balance of stiffness and durability for mounting duties. It is intended to be a stable mounting point rather than a structural chassis change.

What checks should I perform after installation?

After fitting, verify the posts are aligned and torque is even. Conduct a short test run and remeasure body height to confirm the mount is delivering a repeatable reference.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved