Front Bumper X26 Replacement Serpent 402190 for Medius X26  [SER402190]

Price:
£83,497.68
Brand:
Serpent
Model:
SER402190
Condition:
Brand New
Write a review

Technical brief and alignment tips

The Serpent 402190 Bumper X26 is an RC-scale steel front bumper designed as a direct replacement for Serpent Medius X26 steel EP assemblies listed under SER400052. It provides a structural mounting interface at the chassis front that helps manage impact energy flow and offers a repeatable reference for setting bumper height and alignment.

Targeted at hobbyists handling repairs and tuning, this item emphasises consistent fitment and material behaviour rather than claiming performance gains. Confirm chassis compatibility and inspect mounting hardware for wear before fitting this replacement part.

Installation notes: verify part orientation against the old bumper, align the mounting holes with the chassis brackets, and ensure the bumper sits flush to the intended mounts to preserve the designed clearance and shock routing. Since mounting geometries vary across kits, use the chassis' original mounting pattern and fasteners where possible.

Specifications

  • Item: Bumper X26
  • Material: Steel
  • Model Number: SER402190
  • Compatibility: Medius X26 steel EP (SER400052)

The Serpent 402190 Bumper X26 restores original front mounting geometry for Medius X26 steel EP kits and supports standard repair and setup procedures on 1/10 scale touring car chassis.

How can I confirm this matches my chassis version?

Check the chassis code against the compatibility listing for Medius X26 steel EP (SER400052) and compare the mounting pattern to your existing bumper before purchase.

Are there any special care steps for a steel bumper?

Keep the part clean and dry to limit corrosion; if you notice surface rust, remove it and treat or replace the bumper to avoid compromised fit and alignment.

Will this bumper require different mounting hardware?

The bumper is intended to use the chassis' existing fasteners. Replace any stripped or damaged bolts and ensure all fittings are torqued correctly for a secure mount.

Does the part number SER402190 appear on the component?

The specification lists the model number as SER402190; verify packaging or part markings where possible to confirm you have the correct replacement item.

If the bumper does not sit flush, what should I do?

If the bumper does not sit flush after fitting, double-check orientation and mounting hole alignment, swap in the original fasteners, and inspect the chassis mounts for damage; if misalignment persists, consider replacement.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved