FT9 Aftermarket Rear Steering Hub Plate +1mm by Factory Pro O-SCP041  [FP-O-SCP041]

Price:
£9.10
Brand:
Factory Pro
Model:
FP-O-SCP041
Condition:
Brand New
Write a review

FT9 rear steering hub plate upgrade

This Factory Pro aftermarket rear steering hub plate is produced for the Schumacher FT9 platform and supplied as a 1 pair replacement hop-up. The plate is manufactured from graphite and offers a +1mm offset to change rear steering geometry without replacing major suspension parts.

Fitment notes: it replaces the stock rear steering hub plate on FT9 chassis to slightly alter steering linkage geometry. The +1mm offset is intended for nuanced steering response adjustments, useful when tuning turn-in or rear grip balance.

Installation pointers: remove the rear upright to swap the hub plates and use the original fasteners where they suit; make sure suspension travel is free of interference after fitting. Recheck servo endpoints and steering alignment to preserve equal travel left and right.

Tuning note: view this as a small geometric tweak, assess changes with short test runs and combine with modest tyre or toe alterations for predictable handling evolution.

Is this compatible with my FT9 uprights?

Yes, it is intended for the FT9 platform but always verify the plate sits correctly on your uprights and that the fastener lengths are appropriate before locking everything down.

Will I feel big handling differences?

A +1mm offset produces mild, controllable changes to turn-in and rear steering feel; expect small improvements rather than dramatic behaviour shifts.

Any guidance on verifying setup after fitment?

After fitting, check steering travel symmetry, linkage alignment and run a few laps to compare handling. Adjust toe and tyre choices incrementally to complement the offset change.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved