6EXAP Futaba 6-Channel FM 40MHz/ R136F  [6EXAP_c2]

CHARACTERISTICS:

• Aileron, Elevator and Rudder dual cost switch - use this modification to flip between two aileron, elevator and rudder control throw settings. The tosses could possibly be setup but select, but generally speaking, whenever switch is up the throws are greater (higher rate) when the switch is down the throws are less (low rate). This switch additionally flips between exponential expenses (if utilized).
• Flap control dial/Channel 6 - This dial operates the servo connected with channel 6 towards the receiver as soon as your model has flaps this is actually the control accustomed run them.Aileron/elevator control stick -Mounting point for optional neck band.
• Trim levers (all) -Used to get the fundamental or center host to each servo as labeled in diagram.
• Recharging jack - Port for recharging the transmitter batteries along with the included battery power charger.
• On-off switch
• DATA INPUT lever - regularly exchange the values of the different functions presented into the LCD screen.
• Liquid-crystal display (LCD) - shows development modes and values entered.
• MODE key - accustomed scroll through and show the ten or eleven(PCM) various functions.
• CHOOSE key - constantly display the values the existing function.
• Throttle-cut switch - to work well with the throttle-cut function, lower the throttle stick entirely, then drive the throttle-cut switch to completely shut the carburetor and shut linked to the motor.
• Throttle/rudder control stick - Operates the servos attached with channel 3 (throttle) and channel 4 (rudder) in receiver.
• Trainer switch - runs the trainer functions. To make use of as a trainer switch the transmitter must be attached to another transmitter via. a trainer cable (available on their own).
• Retractable landing gear switch/Channel 5 - modification runs the servo associated with channel 5 inside receiver in the event that model has retractable landing gear this could be the control constantly expand and retract the apparatus.
• Antenna - Radiates signals on receiver. Don't ever travel a model without completely expanding the antenna or simply you are going to produce disruption along with other modelers and decrease operational signal variety of the
• transmitter. The antenna might eliminated and replaced with another in the event its unintentionally broken.

INCLUDES:

• Futaba 6-Channel 6EXAP transmitter
• Futaba R136F Receiver
• Change Harness
• Handbook

SPECS:

Transmitter

• T6EXAP Transmitter with programmable blending and 6-model memory.
• Transmitting on 40 / 72 MHz musical company.
• Operating-system: 2-stick, 6-channel system
• Modulation: FM(PPM) and PCM
• Power: 9.6V NT8S600B Ni-Cd battery pack or 12V alkaline battery pack pack
• Present drain: 250mA

Receiver

• R136F narrow musical organization, FM 6 channel receiver.
• Receiving on 40 / 72 MHz musical organization.
• Type: FM, Dual conversion/FM, solitary conversion
• Intermediate frequencies: 455kHz, 10.7MHz/455kHz
• Power requirement: 4.8V or 6V
• Present drain: 9.5mA @ 4.8V
• Size: 1.31 x 1.98 x 0.71" (33.4 x 50.3 x 18.1mm)
• Weight 0.98oz (27.8g)