Futaba FU6A16801 Harness Cord for Voltage Sensing on CDR5000  [FU6A16801]

Voltage sensing lead compatible with CDR5000

The Futaba FU6A16801 terminal harness cord is an RC accessory intended to connect battery packs to a CDR5000 charger for voltage sensing. It provides a dedicated lead to deliver pack voltage to the charger without modifying battery packs or charger housings.

Compatibility is restricted to the CDR5000 charger as stated, so check your charger model and connector type before fitting. The harness is designed as a plug-in lead for monitoring during charge cycles, battery verification and bench setup tasks where pack voltage readout is required.

To install, plug the harness into the charger’s designated sensing terminal and attach the correct battery connector to the pack’s voltage tap or main terminals according to your pack design. Maintain clean contacts, ensure secure connections and avoid strain to preserve accurate readings.

In workshop routines the harness is useful for routine voltage checks between sessions, confirming cell balance reports from the charger, and maintaining a consistent sensing connection while changing batteries on the bench.