This case set acts as a direct replacement outer shell for the Futaba S136G series servo commonly used in scale RC models. It is intended to contain the internal components and restore the housing after damage or wear.
The item is supplied without retail packing per the model description. The sale covers only the case pieces; internal electronics, gear mechanisms, and mounting accessories are not included. Verify the case dimensions and screw hole pattern against your existing servo prior to installation.
Installation recommendations: remove power and disconnect the servo from any controller before disassembly, note the orientation of gears and wiring during removal, gently transfer the electronic module into the replacement case and set gear mesh correctly before final assembly, and fasten screws uniformly to avoid stressing the shell. After reassembly confirm smooth travel and the correct neutral position at low throttle before normal use.
This component is described and intended only as an RC-scale servo part and is not suitable for real vehicle applications.
Copyright © 2008-2026 rcjaz.co.uk All rights reserved
