Futaba FUEBB0155 300mm i-Connector Cord for Servo-to-Receiver  [FUEBB0155]

300mm i-Connector Servo Cord

This Futaba FUEBB0155 300mm i-Connector cord is intended as a neat wiring solution to connect SVi-capable servos or devices to a receiver, helping to keep internal cabling unobtrusive. The 30-strand wire bundle provides flexibility for routing through tight areas around radio boxes and small servo mounts.

Intended compatibility is SVi signal wiring between the servo or SVi device and the receiver; always verify that your receiver accepts SVi connections prior to installation. The cable length and multi-strand layout reduce stress at connectors while enabling tidier wiring runs.

Installation notes: mirror existing loom routes where possible, avoid sharp bends near connector ends, and secure the cable lightly with tape or ties to prevent abrasion on chassis parts. With digital servos using higher refresh rates, ensure connector engagement is complete and check for any noise or dropouts after fitting.

Application note: this item serves as a wiring component rather than a performance upgrade; careful routing and firm connections support consistent servo behaviour during setup and calibration.