Futaba FUHT1 Servo Horn Hole Alignment Gauge 12.5-15mm  [FUHT1]

Servo Horn Hole Alignment for 12.5-15mm Parts

The Futaba FUHT1 drill gauge template is an accessory for RC model builders that helps align and drill mounting holes in servo horns sized between 12.5-15mm. It acts as a simple jig to ensure hole positions are consistent when fitting replacement or hand-cut horns.

Fit the template on the horn, align the aperture over the chosen pivot point, and use a pin vise or low-speed drill through the guide to begin the hole. The template is optimised for standard hobby servo horns made from plastic or composite materials.

Maintaining uniform hole placement prevents imbalance and preserves expected steering response during setup and fine tuning. Use the template for swapping or replicating hole patterns to retain accurate control geometry across parts.