Futaba FUNR7003SB Full-Range 3-Channel S.BUS2 Telemetry Receiver for FASSTest  [FUNR7003SB]

FUTABA R7003SB 2.4GHZ 3-CHANNEL S.BUS2 FASSTEST TELEMETRY HV FULL RANGE RECEIVER
Price:
£40.38
Brand:
Futaba
Model:
FUNR7003SB
Condition:
Brand New
Write a review
alt="FUTABA R7003SB 2.4GHZ 3-CHANNEL S.BUS2 FASSTEST TELEMETRY HV FULL RANGE RECEIVER" title="FUTABA R7003SB 2.4GHZ 3-CHANNEL S.BUS2 FASSTEST TELEMETRY HV FULL RANGE RECEIVER"

3-Channel Full-Range Receiver with S.BUS2

The Futaba FUNR7003SB is a 3-channel receiver engineered for S.BUS2 systems and compatible with FASSTest radios to enable telemetry-equipped setups. It focuses on maintaining a secure full-range link while forwarding telemetry data to the transmitter.

As a bus-capable receiver it consolidates S.BUS2 servos and compatible telemetry sensors. Fit it with attention to antenna placement, ensure S.BUS2 connectors are secure, and mount where signal obstruction is minimised for optimal reception.

For commissioning, bind the receiver to a FASSTest-capable transmitter, switch on telemetry in the transmitter menus as needed, and check S.BUS2 device addressing when several devices are connected. The HV designation means the unit is compatible with higher-voltage servo arrangements when used with matching power components.

Specifications

  • Item Receiver
  • Material Electronic components
  • Model Number FUNR7003SB
  • Compatibility FASSTest 2.4GHz systems, S.BUS2 devices

The FUNR7003SB is an appropriate choice where compact size, S.BUS2 compatibility, and telemetry reporting are required within Futaba FASSTest radio systems.

What is the correct procedure to bind this receiver?

Switch the receiver into bind mode and initiate binding from your FASSTest transmitter. Observe the transmitter feedback and only exit bind mode once the link is confirmed.

How does S.BUS2 improve my model setup?

S.BUS2 reduces wiring by allowing multiple devices to share a single bus and enables those devices to send telemetry back to the transmitter, simplifying installation and monitoring.

Should I be concerned about servo voltage with the HV tag?

HV denotes compatibility with higher-voltage servos. Always check that your servos and power supply are rated for HV operation to prevent electrical issues.

What steps confirm telemetry is active on the transmitter?

Enable telemetry on the transmitter and inspect the telemetry pages for live values or alerts. Verify that each S.BUS2 device appears and that readings update during normal operation.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved