Futaba FUSG29 Replacement Gear Set for S29 and S129 Servos (W/O Packing)  [FUSG29]

FUTABA S29 S129 SERVO GEAR SET (W/O PACKING)
Price:
£2.83
Brand:
Futaba
Model:
FUSG29
Condition:
Brand New
Write a review

Compatibility and Inspection Guidance

This Futaba FUSG29 gear set is an internal replacement intended for Futaba S29 and S129 servos, supplied without outer packing. It is offered as a service part to refresh worn gear trains and restore smooth operation.

Prior to fitting, confirm your servo model and visually compare tooth form and shaft diameter. Ensuring correct physical compatibility prevents misfit and potential damage.

Reassembly advice: keep a record of gear order, confirm free rotation of the output shaft after mesh adjustment, and test under light load before full service use. Standard hobby screwdrivers and a tidy bench are normally all that is required.

How do I confirm this will fit my servo?

Verify the servo model marking and compare the existing gear tooth pattern and shaft size against the replacement set. If markings match S29 or S129, the set is intended for those models.

Can I use these gears in non-Futaba servos?

Fitment to third-party servos cannot be guaranteed. Physical inspection and measurement are required to ensure the teeth and mounting interface match before attempting installation.

What should I check when the part arrives?

Inspect each gear for missing teeth or visible damage, confirm shafts seat correctly, and ensure nothing is bent from transit. Report any defects promptly.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved