Built for the 1/10 Gmade R1 Rock Buggy, this aluminium absorber replaces the original plastic mount to give a stiffer, more consistent bumper interface preferred by many serious builders.
The part acts to absorb and distribute contact loads while keeping bumper mounts aligned after knocks and drops on rough terrain. It is supplied as a single set intended for both the front and rear positions and is offered as a direct-fit upgrade for R1 Rock Buggy chassis.
Installation is straightforward: remove the stock bumper mounting hardware, position the aluminium absorber over the factory mounting points and reuse any compatible screws. No changes to the vehicle's electronics are required since this is a structural component only.
A straightforward aluminium upgrade for those seeking a durable bumper interface on the Gmade R1 Rock Buggy, concentrating on secure mounting and repeatable alignment in 1/10 builds.
Copyright © 2008-2026 rcjaz.co.uk All rights reserved
