GPM TRAXXAS FUNCO PRO SCALE 2WD Rear Differential Gear Set STPS1032T 32/10T - Replacement Part  [STPS1032T]

TRAXXAS FUNCO PRO SCALE 2WD SAND CAR 20CrMnTi Steel 32/10T Rear Differential Gear set - GPM STPS1032T
Price:
£34.69
Brand:
GPM
Model:
STPS1032T
GTIN:
4894538404715
Condition:
Brand New
Write a review

Upgraded rear bevel and pinion for 1/6 sand car applications

The GPM STPS1032T rear differential gear set is an RC replacement tailored to the TRAXXAS FUNCO PRO SCALE 2WD 1/6 sand car. It fits a larger 32T bevel and 10T pinion in hardened 20CrMnTi steel with a spiral tooth profile and M1.6 module to reduce backlash and improve torque transmission under load in sandy environments.

Install the set when the factory bevel or pinion shows wear or if you require a more robust drivetrain for frequent beach or loose-surface driving. Careful reassembly of the diff carrier, accurate shim and mesh adjustments, and correct grease application are essential to maximise service life of the spiral-tooth gears.

Packing includes

  • Diff Bevel Gear 32T - 1pcs
  • Rear Pinion Gear 10T - 1pcs

Original Name / Part No:

7791,7792

Compatible Models

  • TRAXXAS 1/6 FUNCO PRO SCALE 2WD SAND CAR 8S-109076-4

This direct-fit GPM gear set is intended to raise durability and smoothness for sand use; confirm fitment and set mesh carefully during installation to avoid premature wear.

Is this a direct replacement for the TRAXXAS factory gears?

Yes, the set is intended as a direct-fit replacement for the listed rear bevel and pinion, though you should confirm fit and mesh during reassembly of the diff carrier.

How often should I check the gear mesh on sandy runs?

Inspect mesh and tooth faces after every few beach outings; abrasive sand can alter contact patterns and accelerate wear if left unchecked.

Will these gears change driveline feel?

Spiral tooth engagement typically feels smoother and distributes load better, which can reduce impact shock through the drivetrain when mesh and alignment are correct.

Should I use different shims than stock?

Start with the factory shim setup and fine tune mesh as needed; the larger bevel may require micro-adjustments to achieve an even spiral tooth contact pattern.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved