HI0404620 Elevator Lever Rod Kit for Eagle/Freya/EX/SX - Hirobo  [HI0404620]

HIROBO 0404-620 EAGLE ELEVATOR LEVER ROD SET #0404620
Price:
£8.33
Brand:
Hirobo
Model:
HI0404620
GTIN:
4512895108618
Condition:
Brand New
Write a review

Elevator Linkage Rods for Hirobo Eagle Series

The Hirobo HI0404620 elevator lever rod set is supplied as a replacement part for maintaining the elevator linkage on Eagle series helicopters. It is intended to restore the mechanical link between cyclic/servo outputs and the elevator/tail control surfaces.

When installing, check rods for straightness, ensure ball ends move freely without play, and verify correct thread engagement. Properly fitted rods reduce slop and improve predictability of pitch inputs during both hover and transitional flight regimes.

Compatibility

  • Eagle
  • Freya
  • EX
  • SX

Does this suit all Eagle variants?

The kit is listed for Eagle, Freya, EX and SX. Check the part lengths and ball joint fittings against your current rods to ensure compatibility with your specific variant before final assembly.

Are these rods suitable for heavy use flying?

They are designed for regular maintenance replacement. Inspect them regularly if flying aggressively or carrying extra payload; replace at the first sign of wear to avoid increased play.

What pre-flight checks are advised after fitting?

After fitting, centre trims, check for full, smooth travel without binding, and perform a low-altitude hover test to confirm the elevator responds smoothly and without delay.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved