HIROBO HI0414487 Tail Holder — Compatible with Turbulence D3 Tail Assembly  [HI0414487]

Compatibility and fit notes

This tail holder is intended for the Hirobo Turbulence D3 series and is used to secure the tail output linkage while supporting consistent tail shaft alignment. It concentrates on the interface between the tail gearbox output and the linkage, helping to maintain repeatable geometry during setup and repair.

Installation follows standard tail assembly procedures: remove the original holder, position the replacement to line up the tail shaft and linkage, and fasten using the model's existing mounting points and hardware. Verify alignment and any free play prior to initial test flights and torque fasteners to the recommended values.

When maintaining or upgrading the tail mounting interface the holder reduces unwanted flex at the tail output, aiding more consistent tail control behaviour and simplifying adjustments to pitch and tracking.

Choose this part when replacing or upgrading the tail mounting interface on Turbulence D3 models to restore proper tail geometry and streamline setup tasks.