Hirobo HI2506026 Flat Washer 14 x 18.5 x 0.5T, 2 pcs — helicopter general part  [HI2506026]

Fine-thickness washer for helicopter maintenance

The Hirobo flat washer HI2506026 is a compact RC accessory intended for helicopter general parts where precise spacing and repeatable fit are important. Supplied in pairs, they allow consistent gap control during assembly and after servicing.

Compatibility note: these thin washers suit a range of small fittings such as frame joints and linkage mounts where a 14 x 18.5 x 0.5T shim helps achieve the required clearance without changing the structural design. They are intended for fine adjustment rather than carrying major loads.

Fitment guidance: slide the washer onto the bolt or shaft until it sits flush with the mating surface, then confirm alignment and tighten to the recommended torque. When combining washers, check total thickness to avoid introducing unintended preload or altering control geometry.