Hirobo HI2506064 6x10x0.3T Flat Washer for RC Helicopter and Parts  [HI2506064]

Flat washer details and fitting advice

This washer is listed as HIROBO 2506-064 (HI2506064) and serves as a compact, low-height spacer and load distributor for model components. The specification shows a nominal 6×10 size with 0.3T thickness, which is useful when very thin shims are required to control clearances.

Use the washer to distribute load from fasteners, steady small bearings or bushings, and make small adjustments to axial play without adding extra stack height. Since the listing does not include material information, ensure the washer suits the environment and hardware it will contact.

Fitting recommendations: place the washer between mating surfaces or under a screw head to protect against direct contact, check the bore on your chosen bolt or shaft for correct fit, and confirm adequate clearance after assembly. Employ identical washers where uniform spacing is needed across a linkage or mount.