Hirobo HI2532050 Fenestron Cap Screw M2 x 20, 2 pcs  [HI2532050]

HIROBO 2532-050 CAP SCREW M2 X 20 FOR FENESTRON 2PCS #2532050
Price:
£4.62
Brand:
Hirobo
Model:
HI2532050
GTIN:
4512895125998
Condition:
Brand New
Write a review

Cap screw for Fenestron tail assemblies

The cap screw identified by part number HI2532050 is supplied as a pair and measures M2 x 20 for use with Fenestron-style tail assemblies. It is intended to secure components within the tail rotor assembly on RC helicopters using M2 threaded fasteners.

Correct screw selection and secure fitting maintain tail component alignment and contribute to steady tail control. Inspect both the screw and the threaded mounting points for wear or damage prior to installation, and replace screws as a matched set when necessary.

Fitting steps: thread the screw into the Fenestron mounting point until the parts seat, check alignment, then finish tightening. Avoid excessive torque and confirm the tail rotor clears surrounding parts after installation.

How do I check if this screw matches my tail unit?

Compare the M2 thread and 20 mm length to the original fastener or the mating hole depth. If both match, the screw is compatible; if not, measure carefully before fitting.

What should I inspect before tightening?

Ensure mating surfaces are clean, threads are undamaged, and parts sit flush. Confirm that the screw length does not cause interference with internal components before applying final torque.

Is it okay to reuse these screws after removal?

Reusing is acceptable if threads and seating faces remain in good condition. If there is any sign of deformation or thread wear, replace with a new matched pair to avoid failures.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved