HK-50 Series Motor Endbell C-Clip Kit SPCCLIPHK50 by Scorpion  [SPCCLIPHK50]

SCORPION HK-50 SERIES OUTRUNNER MOTOR C-CLIP KIT
Price:
£2.85
Brand:
Scorpion
Model:
SPCCLIPHK50
Condition:
Brand New
Write a review

Motor Endbell C-Clip for HK-50

Specifically for HK-50 series outrunner motors in RC builds, this C-clip kit supplies axial retention to keep the endbell and rotating components located correctly under load and while servicing the motor.

Use these clips only on shafts with a machined groove intended for snap-fit retention; they serve as low-profile axial retainers rather than bearings or spacers. To fit, remove the endbell, place the clip into the shaft groove to restore axial restraint, refit the endbell, and check the shaft for smooth, play-free rotation.

Consistent installation and routine checks reduce axial drift that can affect gear engagement and bearing life in RC setups.

Can I use these clips with modified shafts?

You can use the clips if the modified shaft includes an appropriately sized groove for the C-clip. Verify groove dimensions and clip seat depth to ensure secure retention before running the motor.

Do these clips affect motor tuning or balance?

When fitted correctly the clips have minimal impact on balance. They are thin axial retainers; however, always confirm free rotation and check for vibration after installation to ensure tuning and balance remain optimal.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved