Hobbywing 80020530 - FlyFun 100A HV OPTO V4 ESC Pro Aircraft ESC Unit  [HW-80020530]

HOBBYWING FlyFun 100A HV OPTO V4 - 80020530
Price:
£116.42
Brand:
Hobbywing
Model:
HW-80020530
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Stable aircraft power with the Hobbywing 80020530 - FlyFun 100A HV OPTO V4 ESC

The FlyFun 100A HV OPTO V4 ESC from Hobbywing is aimed at flyers who demand dependable current handling and consistent output. Built with imported components and a low-impedance PCB, it offers enhanced current endurance and thermal performance. It is suitable for a variety of aircraft platforms and can be adjusted using the LED program card for quick configuration changes.

Robust safety features for peace of mind

This ESC incorporates abnormal input voltage detection, overheat protection, throttle signal loss safeguards, and low voltage cutoff to protect both the controller and the battery. These features help maintain reliability across varied flight profiles and conditions.

Specifications

  • Type: Brushless (BL)
  • Voltage: High Voltage (HV)
  • Continuous/Peak Current: 100A/120A
  • Input: 5-12S LiPo
  • BEC Output: No
  • Output Wires: Blue-12AWG-100mm×3
  • Input Connectors: No
  • Output Connectors: No
  • ESC Programming via Transmitter: Supported
  • LED Program Card: Supported
  • LED Program Box: Not Supported
  • LCD Program Box: Not Supported
  • WiFi Module: Not Supported
  • Program Port: Separate Program Wire
  • Firmware Upgrade: Not Supported
  • Size: 88.0x55.0x18.0mm
  • Weight: 112g

The FlyFun 100A HV OPTO V4 is a compact, well protected ESC that suits hobbyists looking for reliable high-voltage performance.

What maintenance does this ESC need?

Routine checks for secure solder joints, clean cooling paths, and correct firmware settings are recommended; ensure connectors and wires are in good condition before each session.

Can I program throttle endpoints with my radio?

Yes, transmitter-based programming is supported along with the LED program card, using the separate program wire connection to access parameters.

Is a separate power supply required for servos?

The ESC does not include a BEC output, so a separate BEC or receiver battery is needed if your servos require power from a dedicated source.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved