Hobbywing has released Xrotor 20A 4IN1 Micro 30901065 under Drone System category
Definitely Integrated
This XRotor 4IN1 Micro ESC not merely includes 4 superior 20A ESCs,
1 integral BEC, but additionally production ports for powering peripherals like FC, digital camera,
and a slot for FC checking present and voltage instantly. The very integral
framework makes the installation and wiring simple and easy clean.
Direction Reversal via TX
Rotation method of each engine are set via transmitter.
This saves the situation of re-soldering/re-connecting after connected/soldered machines to
the ESC freely and discovered motor runs backwards.
Quality Components
The using top end 32-bit supply processors
(aided by the operating regularity as high as 48MHz),
built-in drive ICs, imported quality MOSFETs,
3-ounce copper and 6 quantities of PCBs guarantees less temperature,
greater effectiveness and rapider impact.
Oneshot125, Oneshot42 & Multishot Modes set!
This Xrotor 20A 4IN1 Micro ESC not just supports
regular throttle signals (using the regularity completely to 621Hz),
Oneshot125 (125-250μs) high-speed throttle signals
(utilizing the real-time regularity because high as 3.8KHz),
and Oneshot42 (42-81μs) and Multishot (2-25μs) super
high rate throttle signals. This makes interaction
between FC and ESC more agile, throttle linearity smoother,
and throttle response rapider.
DEO Technology/Active Freewheeling
The DEO (Driving effectiveness Optimization) technology
applied inside ESC has numerous advantages:
● Active braking. Whenever reducing the throttle amount, the engine will
decelerate quickly. This type of function allows pilots to easier
perform all maneuvers like razor-sharp turns, altitude modifications,
and sudden braking.
● greater driving effectiveness, longer journey time.
● Lower ESC temperature and a far more dependable procedure.
Motor Lock-up Protection
This XRotor 20A 4IN1 Micro ESC lessens its production to engine straight away
about detects the engine shaft is locked up.
Splash-proof
The whole circuit board and all forms of sun and rain on
it have gone through nano-coating treatment;
this may end up in the XRotor 20A 4in1 Micro ESC splash-proof.
Specifications
- Cont./Peak active : 20A×4/25A×4
- LiPo Cells : 3-4S LiPo
- BEC manufacturing : 5.3V/12V，3A
Wires & Connectors
- Output Wires : No cables but solder tabs
- Input Connectors : No
- Output Connectors : No
- Firmware : HW Special Program for FPVs
- ESC Programming : Supported
- Stick Programming : Transmitter
- DEO : Supported
- Throttle Range Calibration : Supported
- Oneshot125 Mode : Supported
- Oneshot42 Mode : Supported
- MultiShot Mode : Supported
- Timing : maybe not Supported
- Motor Rotation : Supported
Size & Weight
- Size : 54x36x7mm
- Weight : 24.5g
Applications
