HPI Baja Front Rim Frame Nylon Carrier with Alloy Ten-Pole Face BJ1003F by GPM  [BJ1003F]

HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F
Price:
£57.98
Brand:
GPM
Model:
BJ1003F
GTIN:
4894538025002
Condition:
Brand New
Write a review
alt="HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F" title="HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F"
alt="HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F" title="HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F"
alt="HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F" title="HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F"

Front rim replacement for HPI Baja

This aftermarket front rim frame suits HPI Baja buggies and is identified as model BJ1003F. The component pairs a molded nylon carrier for load support with an alloy ten-pole face that gives local stiffness and a distinctive wheel finish.

Designed as a straightforward replacement or upgrade, the part prioritises secure wheel mounting and predictable responses when running off-road. It is intended to work with familiar Baja wheel hubs and standard mounting hardware; always confirm hub hex and offset compatibility before fitting.

Fitting is a simple wheel service task: remove the wheel, position the rim frame on the hub seat, and tighten the original wheel fixings. Expect the nylon carrier to provide some give for impact absorption, while the alloy face concentrates mass nearer the rim edge and may slightly change rotational inertia.

Specifications

  • Item: Front Rims Frame
  • Material: Nylon and Alloy
  • Model Number: BJ1003F
  • Compatibility: HPI Baja

Select the BJ1003F rim frame when replacing a damaged front carrier or when you want a mix of nylon flexibility and alloy-pattern stiffness for HPI Baja wheels.

How do I check compatibility before purchase?

Measure your wheel hub hex and check wheel offset against the rim frame specifications to make sure the part will sit correctly on your Baja hubs.

Are any extra spacers required?

Most installations will not need additional spacers; retain any original washers or shims and refit them as required to maintain correct wheel alignment.

What inspection routine is recommended?

After each run, remove grit, inspect the carrier and mounting holes for cracking or deformation, and ensure the rim face remains true to prevent vibration.

Will the alloy face dent easily?

The alloy face increases surface stiffness but is decorative and localised; inspect for nicks after heavy impacts and replace if wheel seating or balance is affected.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved