HPI Bullet 3.0 MT and ST Front Suspension Arm Alloy BMT055 by GPM  [BMT055]

Front alloy suspension arm for Bullet 3.0 series

This alloy front suspension arm is built for RC use on HPI Bullet 3.0 MT and ST chassis and functions as a direct swap for the stock front arm. It is intended for front-end repair, maintenance, or tuning and is supplied as a 1pr set for hobby nitro buggy applications.

Installation is straightforward with common RC tools such as hex drivers; in most cases you can reuse existing mounting pins and ball studs unless they are damaged. The alloy construction delivers higher stiffness against plastic arms, which can change steering feedback and suspension behaviour, so perform modest setup checks after fitting.

Offered as a durable replacement, this alloy front suspension arm suits hobbyists fitting or tuning the HPI Bullet 3.0 MT and ST. Use it to replace worn arms or to adjust front-end rigidity, and confirm steering and mounting compatibility prior to full use.