HPI Bullet 3.0 MT/ST Aftermarket Graphite Radio Tray (Blue) GBMT014B by GPM  [GBMT014B]

Aftermarket radio tray for Bullet 3.0 MT and ST

This graphite radio tray is supplied as an RC-scale replacement part for HPI Bullet 3.0 MT and ST chassis running Nitro engines. It creates a stable mounting area for the receiver, servo and related small electronics while helping to maintain tidy wiring within the vehicle chassis.

Constructed from graphite with a blue coating, the tray is designed to sit in the vehicle radio bay using the stock mounting pattern for Bullet 3.0 MT and ST platforms. The objective is a stiff, low-profile panel that conforms to normal 1/10 off-road component placement and avoids extra bulk.

Fitment notes: the tray comes as one piece and should be fastened using the existing screw points on compatible chassis. Route antenna and power leads along the original paths and check clearance near the servo and fuel tank on Nitro-fitted Bullet 3.0 MT/ST variants before final tightening.

Tuning and maintenance role: install this tray to keep radio gear in a stable location during setup and to make receiver or servo replacement simpler without altering the main chassis geometry.